Additional data transmission scheme for the ATSC terrestrial DTV systems based on a low rate systematic irregular repeat-accumulate code

In a Single Frequency Network (SFN) for Advanced Television Systems Committee (ATSC) terrestrial digital television (DTV) system, the interferences induced by the multiple transmitters and/or repeaters using same frequency are unavoidable. To ease the interference handing in the SFN for ATSC DTV system, transmitter identification (TxID) signal is recommended in the ATSC terrestrial DTV system. The TxID signal is embedded in the ATSC DTV signal and transmitted from each transmitter and repeater within the SFN and in ATSC recommended practice (RP) A/111, Kasami sequence is recommended as the TxID signal. In this paper, we propose an additional data transmission scheme using the TxID signal. In the proposed scheme, the Kasami sequence not only acts as the conventional TxID of the SFN for ATSC terrestrial DTV system but also carriers the additional data bits on its polarity and the code phase.

Several previous studies have demonstrated that additional low-rate data can be transmitted in Advanced Television Systems Committee (ATSC) terrestrial digital television (DTV) systems by modulating the polarity of the transmitter identification (TxID) signal. Previously proposed additional-data transmission schemes can offer an additional reliable transmission channel, and thus they have a very large coverage area compared to that of a DTV signal. Unfortunately, as the cost of a reliable transmission, they have a limitation in their maximum data rate. In this paper, we propose a new additional data transmission scheme based on sequence phase modulation (SPM) to increase the data rate. The proposed scheme exploits not only the polarity but also the phase of a TxID signal, and thus it significantly enhances the data rate compared to conventional schemes.

This paper proposes an improved additional data transmission (ADT) system based on low density parity check (LDPC) code which can transmit an additional data stream in the Advanced Television Systems Committee (ATSC) terrestrial digital television system. The LDPC code based ADT system can offer an additional data of rate up to a few megabits per second (Mbps) which is significantly increased compared to the conventional data transmission schemes used in the transmitter identification system.

This paper investigates high-performance decoder design for regular and irregular repeat-accumulate (RA) codes of large block length. In order to achieve throughputs and bit-error rate performance that are inline with future trends in high-speed communications. high-throughput and low-power decoders of low complexity are needed. To meet such conflicting requirements for long codes, the concept of architecture-aware RA (AARA) code design is proposed. AARA code design decouples the complexity of the decoder from the owe structure by inducing structural regularity features that are amenable to efficient and scalable decoder implementations. Design methods of AARA codes with structured permuters for which an iterative decoding algorithm performs well under message-passing are analogous to those for AA LDPC codes. Algorithmic and architectural optimizations that address the latency, memory overhead, and complexity problems typical of iterative decoders for long RA codes are investigated, and a staggered decoding schedule is introduced. AARA decoders using the proposed schedule have substantial advantage over serial and parallel RA decoders.

In a single frequency network (SFN) for the Advanced Television Systems Committee (ATSC) terrestrial digital television (DTV) system, co-channel interference induced by the multiple transmitters and/or repeaters which use the same output channel is inevitable. Since the presence of interference results in the performance degradation of the SFN, it is crucial to manipulate the interference by adjusting the transmit power and the emission time of each transmitter and repeater within the SFN. In the ATSC terrestrial DTV system, in order to facilitate the interference manipulation process, a transmitter identification (TxID) signal which is embedded in the transmit signal from each transmitter and repeater is recommended. However, such an embedded signal may degrade the DTV signal quality even though the injection level of the TxID signal is very low compared to the DTV signal. Hence, the effect of the TxID signal on the DTV signal needs to be investigated before deploying the SFN with TxID signal. In this paper, the effect of the TxID signal on the performance of legacy DTV receivers is investigated not only with extensive computer simulation but also with laboratory and field tests. According to the various test results, the average performance loss of the conventional DTV receiver due to the TxID signal is less than 0.2 dB when the TxID signal is injected at 30 dB below the DTV signal power.

We present an extrinsic information transfer (EXIT) chart-based design technique for irregular repeat-accumulate (IRA) codes used in 2-D magnetic recording (TDMR) turbo-equalization systems. The channel model includes Voronoi magnetic grains, 2-D intersymbol interference (2D-ISI) and additive white Gaussian noise (AWGN). The receiver uses a 2D-ISI BCJR equalizer and an IRA decoder. For one outer equalizer-decoder iteration, we propose theory and simulation-based methods for computing EXIT curves. The simulation method calculates experimental EXIT curves for the check node decoder (CND) and the combination of the variable node decoder (VND) and an equalizer. The theoretical approach recursively calculates CND and VND Gaussian mixture model parameters in order to calculate EXIT curves. We then fit the VND and CND EXIT curves to find optimized variable node degree distributions. Simulation results show that the TDMR-optimized IRA codes achieve up to a 6.2% density increase in user bits/grain (U/G) compared with IRA codes designed for AWGN channels. The theory-based code designs achieve the same or better U/G as the simulation-based designs, but require 98% less design computation time. We also derive optimized IRA codes for iterative turbo-equalization; these codes can achieve simultaneous U/G gains and SNR savings compared with AWGN-optimized codes.

In this paper we propose an innovative channel coding scheme called 'Accumulate Repeat Accumulate codes' (ARA). This class of codes can be viewed as serial turbo-like codes, or as a subclass of Low Density Parity Check (LDPC) codes, thus belief propagation can be used for iterative decoding of ARA codes on a graph. The structure of encoder for this class can be viewed as precoded Repeat Accumulate (RA) code or as precoded Irregular Repeat Accumulate (IRA) code, where simply an accumulator is chosen as a precoder. Thus ARA codes have simple, and very fast encoder structure when they representing LDPC codes. Based on density evolution for LDPC codes through some examples for ARA codes, we show that for maximum variable node degree 5 a minimum bit SNR as low as 0.08 dB from channel capacity for rate 1/2 can be achieved as the block size goes to infinity. Thus based on fixed low maximum variable node degree, its threshold outperforms not only the RA and IRA codes but also the best known LDPC codes with the dame maximum node degree. Furthermore by puncturing the accumulators any desired high rate codes close to code rate 1 can be obtained with thresholds that stay close to the channel capacity thresholds uniformly. Iterative decoding simulation results are provided. The ARA codes also have projected graph or protograph representation that allows for high speed decoder implementation.

Single frequency network (SFN) enables efficient use of spectrum by allocating the same frequency among multiple transmitters. In order to efficiently design and manage the SFN, the Advanced Television Systems Committee (ATSC) 3.0 physical layer standard has adopted transmitter identification (TxID) technology which allows to measure the individual and/or whole network channel response, such as power and time delay of the broadcast signal from transmitters. Since TxID is embedded into the host ATSC 3.0 frame as radio frequency (RF) watermark, it is transparent to legacy ATSC 3.0 receivers and only a specially designed TxID analyzer is able to detect it. This paper presents new TxID detection methods that improve the detection performance of ATSC 3.0 TxID signal by resolving the problems and limitation of the conventional TxID detection method. The superiorities of the proposed detection methods are verified through computer simulation, laboratory test, and field trial.

In this paper, we analyze the coexistence between the International Mobile Telecommunications (IMT) system and the digital television (DTV) system in the 700MHz band. The 700MHz band is now called the "digital dividend" and is expected to be allocated to IMT services. This plan could cause mutual interference between existing broadcasting and the IMT services. The members in the Asia-Pacific Telecommunity Wireless Group are currently discussing the coexistence issues associated with the 700MHz band. In order to allocate this band to the IMT services without harming the DTV system, coexistence problems should be solved. This paper presents the simulation methodology for analyzing the mutual interference between the IMT and DTV system and provides the results of the performance degradation of the two systems.

This paper describes the architecture, functionality, and design of HDVO-a high definition video co-processor from Philips Semiconductors. The coprocessor design is modular and functionally complete, and is intended to be a part of and function as the primary picture/video composition hardware in any media-processor chip targeted at Digital Television (DTV) applications. Essentially a screen-refresh engine, HDVO can mix multiple video and graphics planes and is capable of scaling vertically and horizontally pictures of the highest resolution (1920/spl times/1080) specified in the DTV standard prescribed by the United States Advanced Television Systems Committee (ATSC). HDVO can efficiently process all (eighteen) ATSC video formats, including video generation for picture-in-picture display, and is currently being wed as an on-chip video coprocessor in the TM-2700 digital television chip. TM-8700 is the second generation of an architectural family of programmable multimedia processors from Philips Semiconductors and it not only supports all ATSC formats, from standard-definition to wide-angle high-definition video, but has also the power to handle High-Definition Television (HDTV) video and audio source decoding (high-level MPEG-2, AC-3 and ProLogic audio, closed captioning, etc.) as well as the flexibility to process advanced interactive services.

The most recent standard for broadcast services, Advanced Television System Committee—Third Generation (ATSC 3.0), has adopted co-located multi-antenna schemes and Layered Division Multiplexing (LDM) in order to increase the capacity and reliability compared to former Digital Terrestrial Television (DTT) systems. ATSC 3.0 has adopted both technologies separately, but no combination of them is planned yet. Compared to baseline LDM case, use of several antennas allows for diverse parametrization for each layer. This paper analyzes the potential combination of co-located Multiple-Input–Multiple-Output (MIMO) schemes with LDM. A trade-off analysis between complexity constraints and performance benefits is evaluated.

An efficient decision feedback equalizer for the ATSC DTV receiver

In this paper, simulation is conducted to study the interference to digital television (DTV) system due to the introduction of Long Term Evolution (LTE) system. Access coverage loss curves and capacity performance of DTV system are plotted with Adjacent Channel Interference Ratio (ACIR). The results indicate that minimum interference effects on DTV system can be achieved when deploying LTE system on its adjacent channels if proper separation is kept.

<p>Advanced Television Systems Committee (ATSC) 3.0, the new generation digital terrestrial television standard, has been designed for facing the new challenges of the future broadcasting systems. ATSC 3.0 has been built using the most recent cutting-edge technologies. Layered division multiplexing (LDM) is one of the major components of the new system baseline. LDM provides a tool to make flexible use of the spectrum for delivering simultaneous services to stationary and mobile services. This paper presents the performance evaluation of ATSC 3.0 core services in mobile scenarios using LDM. Simulation results are presented to analyze the influence of different LDM ensemble configuration modes for mobile reception. The simulation results have been also confirmed by laboratory tests under different channel models. The signal to noise ratio threshold values confirm the excellent behavior of ATSC 3.0 and LDM in mobile and portable scenarios.</p>

"(c) 2015 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other users, including reprinting/ republishing this material for advertising or promotional purposes, creating new collective works for resale or redistribution to servers or lists, or reuse of any copyrighted components of this work in other works.")