Detection Schemes for ATSC 3.0 Transmitter Identification in Single Frequency Network

In a Single Frequency Network (SFN) for Advanced Television Systems Committee (ATSC) terrestrial digital television (DTV) system, the interferences induced by the multiple transmitters and/or repeaters using same frequency are unavoidable. To ease the interference handing in the SFN for ATSC DTV system, transmitter identification (TxID) signal is recommended in the ATSC terrestrial DTV system. The TxID signal is embedded in the ATSC DTV signal and transmitted from each transmitter and repeater within the SFN and in ATSC recommended practice (RP) A/111, Kasami sequence is recommended as the TxID signal. In this paper, we propose an additional data transmission scheme using the TxID signal. In the proposed scheme, the Kasami sequence not only acts as the conventional TxID of the SFN for ATSC terrestrial DTV system but also carriers the additional data bits on its polarity and the code phase.

In a single frequency network (SFN) for the Advanced Television Systems Committee (ATSC) terrestrial digital television (DTV) system, co-channel interference induced by the multiple transmitters and/or repeaters which use the same output channel is inevitable. Since the presence of interference results in the performance degradation of the SFN, it is crucial to manipulate the interference by adjusting the transmit power and the emission time of each transmitter and repeater within the SFN. In the ATSC terrestrial DTV system, in order to facilitate the interference manipulation process, a transmitter identification (TxID) signal which is embedded in the transmit signal from each transmitter and repeater is recommended. However, such an embedded signal may degrade the DTV signal quality even though the injection level of the TxID signal is very low compared to the DTV signal. Hence, the effect of the TxID signal on the DTV signal needs to be investigated before deploying the SFN with TxID signal. In this paper, the effect of the TxID signal on the performance of legacy DTV receivers is investigated not only with extensive computer simulation but also with laboratory and field tests. According to the various test results, the average performance loss of the conventional DTV receiver due to the TxID signal is less than 0.2 dB when the TxID signal is injected at 30 dB below the DTV signal power.

"(c) 2015 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other users, including reprinting/ republishing this material for advertising or promotional purposes, creating new collective works for resale or redistribution to servers or lists, or reuse of any copyrighted components of this work in other works.")

Several previous studies have demonstrated that additional low-rate data can be transmitted in Advanced Television Systems Committee (ATSC) terrestrial digital television (DTV) systems by modulating the polarity of the transmitter identification (TxID) signal. Previously proposed additional-data transmission schemes can offer an additional reliable transmission channel, and thus they have a very large coverage area compared to that of a DTV signal. Unfortunately, as the cost of a reliable transmission, they have a limitation in their maximum data rate. In this paper, we propose a new additional data transmission scheme based on sequence phase modulation (SPM) to increase the data rate. The proposed scheme exploits not only the polarity but also the phase of a TxID signal, and thus it significantly enhances the data rate compared to conventional schemes.

The Advanced Television System Committee (ATSC) is currently developing the next-generation U.S. Digital Terrestrial Television (DTT) standard, known as ATSC 3.0. Two disruptive technologies for the physical layer are being evaluated, Layer Division Multiplexing (LDM) and Time Frequency Slicing (TFS). LDM consist in the transmission of a signal composed of two independent signals (layers) which are superimposed together at different power levels. These two layer can be configured with the desired robustness and capacity. LDM enables the efficient provision of services addressed to mobile and fixed reception in a more efficient way than the classical Frequency Division Multiplexing (FDM) and Time Division Multiplexing (TDM) since full bandwidth and transmission time are used in both layers. However, practical operation is restricted due to several implementation constraints such as the use of common parameters and transmitter blocks for both layers (e.g. a common time interleaver). The use of TFS allows for an improved frequency diversity by the distribution of the service data across multiple Radio Frequency (RF) channels instead of using a single RF channel. The paper investigates the potential gains provided by the increased frequency diversity with TFS in conjunction with LDM.

Digital terrestrial television systems (DVB-T) using single frequency networks (SFN) based on OFDM modulation schemes have been deployed during the last years. Such SFN topology make it possible to increase the number and quality of services offered due to their more efficient use of the spectrum compared to multiple frequency networks (MFN). Moreover, SFN can cut down on the number of transmitters along with their powers because of the internal gain of the network, saving overall deployment and maintenance costs, and even achieving coverage improvements or a decrease of the outage probability over larger geographical areas through the reuse of frequencies. In this work, an approach to analyze and improve the coverage of a SFN over the most populated regions with the least possible economic investment is proposed, considering several strategies to synchronize and combine the signals at the receiver side and using a hybrid algorithm, mixing up the real and binary versions of the Particle Swarm Optimization algorithm (PSO), to optimize the static delays, gains and orientations for each SFN transmitter and decide whether each sector antenna must be active or not.

In this paper, we propose an additional data transmission scheme for the ATSC (Advanced Television Systems Committee) terrestrial DTV (digital television) systems based on a low rate systematic irregular repeat-accumulate (SIRA) code. Unlike the previously proposed additional data transmission scheme using TxID (transmitter identification) signals, the proposed scheme conjuncted with a DTV VSB signal cancellation technique is suitable for high data transmission. Compared to the previous additional data transmission scheme based on a low rate systematic repeat-accumulate code, the BER performance of the proposed scheme is significantly improved. The additional data is encoded with a simplified IRA channel coding scheme and injected to the conventional VSB signals with the bury ratio (BR) of -27 dB. With the proposed scheme, an additional data of rate up to 1 Mbps can be transmitted along with the ATSC terrestrial DTV signals by minimizing the detrimental effects on the ATSC terrestrial DTV systems.

This paper proposes an improved additional data transmission (ADT) system based on low density parity check (LDPC) code which can transmit an additional data stream in the Advanced Television Systems Committee (ATSC) terrestrial digital television system. The LDPC code based ADT system can offer an additional data of rate up to a few megabits per second (Mbps) which is significantly increased compared to the conventional data transmission schemes used in the transmitter identification system.

In digital broadcasting system single frequency network (SFN) technologies are often considered for the efficiency of frequency allotment. In SFN, All the transmitters within the broadcasting service area use the same frequency. In this paper, we discuss the performance and evaluate some coverage criterions for SFN in digital video broadcasting - terrestrial (DVB-T) and on-channel repeater (OCR) in the Advanced Television Systems Committee (ATSC). Also, we propose method and simulation for coverage planning and estimation.

The next generation digital TV (DTV) broadcast, namely Advanced Television System Committee (ATSC) 3.0, relies on substantial single frequency networks (SFN), each of which requires a studio to transmitter link (STL) to transmit data from the broadcast gateway (BG), leading to significant construction costs. Therefore, the wireless in-band distribution link (IDL) technology is proposed, which uses layered-division multiplexing (LDM) to transmit the STL data via wireless links from the BG to the SFN transmitters within the same spectrum as the broadcast services. In this paper, we propose the time synchronization and signal detection algorithm for wireless IDL systems with both unicast and broadcast signals. We introduce two multiplexing schemes, N-LDM and 3-LDM, and demonstrate their superiority over traditional frequency division multiplexing (FDM). To overcome the challenge of multi-access interference and synchronization errors caused by multipath, we develop a unique word (UW) design algorithm for transmitted signals and a double threshold correlation detection algorithm (DTCDA) that outperforms traditional ones. We employ a second threshold to enhance detection performance at low signal-to-noise ratios, and utilizes successive interference cancellation (SIC) to mitigate multiple-access interference. More importantly, our approach requires no knowledge of the unicast user number or channel state information. Simulation results validate the effectiveness of the proposed scheme.

Single frequency networks (SFN) broadcast is an efficient method to provide broadcast services in cellular networks. How to select broadcast services by the SFN operation to trade off between the occupied bandwidth and the SFN performance including spectrum efficiency and broadcast service continuity is a new problem. To the best of our knowledge no solutions have been proposed to solve this problem so far in the literature. We define the problem of SFN broadcast services selection as a knapsack problem and solve it to minimize the occupied bandwidth while at the same time guaranteeing the SFN performance. Based on the solution, several SFN broadcast services selection algorithms are proposed which vary in the reselection policy. Numerical results show that our proposed algorithms are applicable to different cases with different system requirements and in particular, that the semi-dynamic-SFN broadcast services selection algorithm is an efficient solution in general.

DVB-T2 broadcasting with a single frequency network (SFN) allows an efficient management of frequency utilization and extends the coverage area, which will enable more people to view a broadcast. The SFN mode also increases the concentration of the signal in overlap areas. However, some difference of overlap areas in actual use of SFN networks may have some degradation of the received signal due to the effect of the SFN. In this research, we analyze SFN broadcasting in SISO mode. This paper represents the effects of delays on the SFN signal over different delay times within the guard interval (GI) by analyzing the minimum reception threshold. The analysis of received signal power, MER, bBER, LBER, and noise margin are studied using an actual digital television transmitter for the experiment. The results show that the minimum thresholds for a delay time at 0 microseconds will require higher receive signal power than other delay times within the GI. The results of this experiment are useful in designing the SFN network and make it possible to determine the appropriate C/N threshold for the design of the digital terrestrial television network.

This paper presents the results of laboratory tests simulating the reception in a Single Frequency Network (SFN) with ATSC on commercial receivers. The results of the commercial receivers are important because the viability of the SFNs with ATSC depends mainly of the performance of the receivers. Additionally, the basic implications of the results on the SFNs design are presented. Mexico officially adopted ATSC for Digital Terrestrial Television (DTT) service more than 10 years ago, but the analog transmissions stopped until December 31, 2015. The results of these tests can contribute to the planning of SFNs with ATSC. ATSC does not use OFDM modulation unlike others DTT systems. For this reason, the operation of a SFN with ATSC depends primarily on receiver equalizer capabilities. However, the performance of the receivers have improved over the years. The tests focus on the relationship between power and delay of the two signals received on the SFN, and the methodology includes the simulation of three reception environments: without multipath, outdoor reception and indoor reception.

The single frequency network (SFN) has been assumed worldwide by telecommunication operators to save radio frequency resources and homogenize the network. Its applications have transcended the digital terrestrial television and digital radio to become part of the key techniques of the broadband and broadcast convergence for LTE-A, 5G and beyond. However, the transition from a multi frequency network (MFN) to an SFN involves multiple measurement campaigns and tuning of the network to achieve the expected up-performance and quality of service. This paper aims to propose a machine learning model to predict the SFN performance from the legacy MFN parameters. The model is based on regression and classification machine learning algorithms concatenated in three consecutive stages to predict SFN electric-field strength, modulation error ratio and gain. The training and test processes are performed with a dataset of 389 samples from an SFN/MFN trial in Ghent, Belgium. The best performance is obtained with concatenating gradient boosting, random forest, and linear regression, which allows predicting the SFN electric-field strength with an R-2 of 92%, the modulation error ratio with 95%, and SFN gain with 87% from only MFN and position data. Besides, the model allows classifying the data points according to positive or negative SFN gain with an accuracy of 93%.

OFDM is expected to be a suitable modulation method for digital terrestrial broadcasting systems. One of the reasons is that it makes it possible to construct a single frequency network (SFN) and to make effective use of the frequency bands. In a SFN environment, however, some receivers will obtain their signals from more than one transmitter. This causes two effects, intersymbol interference and degradation of frequency characteristics due to echoes. This paper describes a theoretical study on the latter effect in a variety of signal numbers, D/U ratios and delays arriving at the receiving antenna and the BER (bit error rate) distribution within the coverage area of SFNs in a variety of the transmitter numbers with computer simulations on a virtual plain. Finally we suggest a method to improve the quality in a coverage area.