Performance Research for Regular LDPC Codes in TD-SCDMA System

In this paper, we propose a concatenated code by combining a Recursive Systematic Convolutional (RSC) code with a Low-Density Parity-Check (LDPC) code. The proposed concatenated code is encoded in parallel by an RSC encoder and an LDPC encoder without interleavers between them. When decoding the proposed concatenated code, the information bits are decoded by two decoding algorithms, and soft information is exchanged between the RSC decoder and the LDPC decoder. This allows for the elimination of wrong codewords output by each decoder. The use of an LDPC code allows us to halt the decoding process when the valid codeword is obtained. We evaluate the error rate performance of the proposed concatenated code by computer simulations. We show that the proposed concatenated code does not have a high error floor, and achieves better BLock Error Rate (BLER) performance than either conventional LDPC codes or conventional turbo codes in the high Eb/No region. We also show that since the proposed concatenated code can correct wrong codewords output by each decoder, it achieves better BLER than the regular LDPC code at the same Bit Error Rate (BER).

We propose a novel concatenated coding scheme combined Low Density Parity Check(LDPC) code and vertical Bell Labs layered space-time (VBLAST) code to improve the bit error rate (BER) performance for Free-space optical (FSO) communication links with On Off Keying(OOK) modulation. In the scheme, π-rotation encoding and belief-propagation (BP) decoding algorithm are employed in LDPC code, and minimum mean-square error (MMSE) soft-decision decoding algorithm is used for VBLAST code. Moreover, a joint iterative detection and decoding algorithm of VBLAST code and LDPC code is used to improve the overall link performance. At last, the BER of the proposed scheme over lognormal atmospheric turbulent fading channels is analyzed by using Monte Carlo method. The result shows that the BER of the proposed concatenated coding scheme is much improved than that only use VBLAST code scheme.

Low-density Parity check codes (LDPC) are gaining interest for high data rate application in both terrestrial and spatial communications which requires low bit error rate. This paper proposes an algorithm through which the best parity check matrix is obtained for irregular low density parity check codes, which reduces the Bit Error Rate ,Frame Error Rate and computational complexity. Tanner graph also called a bipartite graph format in an Low Density Parity Check (LDPC) code design contains many short cycles; it will produce a computational complexity in a code design process and it degrades the code performance. To overcome this effect, we proposed an new algorithm which obtains a best final parity check matrix. Throughout the paper we will give the detailed description of an efficient algorithm proposed. The complexity is studied graphically and analytically. Using proposed algorithm, cycles of length four observed in corresponding matrix are removed. Each matrix is evaluated over a noisy Additive White Gaussian Noise (AWGN) channel. Bit Error rate and Frame error rate is calculated. The results are compared with randomly generated best parity check matrix. Simulation results shows that proposed method successfully overcomes the computational complexity and meets the near Shannon limit.

Orthogonal frequency division multiplexing (OFDM) is a very attractive technique for high-bit-rate data transmission in a multipath fading environment that causes intersymbol interference (ISI). There are many error-correcting codes applied to OFDM, convolutional codes, Reed-Solomon codes, turbo codes, and so on. Low-density parity-check (LDPC) codes have attracted much attention particularly in the field of coding theory. LDPC codes were proposed by Gallager (1962) and the performance is very close to the Shannon limit with practical decoding complexity like turbo codes. We propose LDPC coded OFDM (LDPC-COFDM) systems to improve the bit error rate (BER) of OFDM. We show that the BER of the LDPC-COFDM is worse than that of the TCOFDM on an AWGN channel, while that of the LDPC-COFDM is better than that of the turbo-coded OFDM (TCOFDM) on a frequency-selective fading channel.

In communication systems, the transmitted data is corrupted by channel perturbations, such as noise and fading, which affect the reliability of the received data. Error correction codes are employed to mitigate channel perturbations. However, design and implementation of good and efficient error correction codes remains an open problem. In this paper, Low Density Parity Check (LDPC) codes are considered as they provide a reasonable trade-off between computational complexity and reliability. Good LDPC codes should ideally provide low complexity, close to capacity acheivable transmission rate, high coding threshold, and high decoding stability. In this paper, we investigate a joint LDPC code optimization algorithm using Genetic Algorithm (GA) and Linear Programming (LP) to determine the variable nodes and check nodes degrees distributions. EXIT chart analysis and Frame Error Rate (FER) performance are used to validate the proposed method.

In this paper, we construct binary spatially coupled (SC) low-density parity-check (LDPC) codes based on Euclidean geometry (EG) LDPC codes for storage applications, where high error correction capability, extremely low uncorrectable bit error rate (UBER), and low decoding complexity are required. We propose a systematic way to construct the families of SC LDPC codes from $(m,2^{s})$ EG LDPC codes, which are termed EG-SC LDPC codes. In the construction method, we propose a 2-D edge-spreading process to construct the base matrix of EG-SC LDPC codes, which consists of matrix unwrapping and periodically time-varying of a protograph. A lower bound on the rank of the parity-check matrix of an EG-SC LDPC code is derived. We evaluate the error rate performance of the constructed EG-SC LDPC codes by using a weighted bit-flipping decoding algorithm for its low decoding complexity. Numerical results show that the UBER performance of the constructed EG-SC LDPC codes is superior to that of their EG LDPC code counterparts, and show no error floor compared with the constructed protograph SC LDPC codes and regular LDPC codes.

Turbo codes are attractive compared with Low Density Parity Check (LDPC) codes for Forward Error Correction (FEC) applications mainly due to their superior performance, especially at low Signal-to-Noise Ratio (SNR) such as are common in Powerline channels. For example, IEEE 1901-FFT PHY used the Turbo coding scheme defined in the HomePlug AV standards. However, patent fees are usually required for each turbo-code enabled manufactured device. The objective of this paper is to examine whether unlicensed LDPC codes, with optimized choices of block lengths, could be a viable alternative for future Powerline Communications (PLC) applications. The paper shows that the performance of the LDPC codes can approximate that of the Turbo codes with higher block lengths, on channels with typical and realistic PLC characteristics. The paper also shows that the additional complexity associated with this increase in block length can be mitigated by the use of Quasi-Cyclic LDPC (QC-LDPC) codes.

Ultra low bit error rate (BER) is required in high speed communications such as the 100 Gbit/s long haul optic communications. In this paper, a type of simple product codes is proposed using low density parity check (LDPC) codes with very high rate algebraic block codes by exploiting the sparsity of LDPC decoding failure and sparse error distribution in an LDPC frame with errors. Specifically, different with traditional product codes, the information bits are first encoded with very high rate algebraic block codes of low encoding and decoding complexity. Even the block codes correcting a single error using algebraic decoding method can be used. Then, LDPC codes are used as the inner code to obtain a low decoding threshold using iterative decoding. This design scheme can achieve the ultra low bit error rate at relatively low signal-to-noise ratios. The cost of the proposed scheme is the relatively large latency, which is not so critical for the ultra high speed communications.

Channel coding is a fundamental procedure in wireless telecommunication systems and has a strong impact on the data transmission quality. This effect becomes more important when the transmission must be characterised by low latency and low bit error rate, as in the case of vehicle-to-everything (V2X) services. Thus, V2X services must use powerful and efficient coding schemes. In this paper, we thoroughly examine the performance of the most important channel coding schemes in V2X services. More specifically, the impact of use of 4th-Generation Long-Term Evolution (4G-LTE) turbo codes, 5th-Generation New Radio (5G-NR) polar codes and low-density parity-check codes (LDPC) in V2X communication systems is researched. For this purpose, we employ stochastic propagation models that simulate the cases of line of sight (LOS), non-line of sight (NLOS) and line of sight with vehicle blockage (NLOSv) communication. Different communication scenarios are investigated in urban and highway environments using the 3rd-Generation Partnership Project (3GPP) parameters for the stochastic models. Based on these propagation models, we investigate the performance of the communication channels in terms of bit error rate (BER) and frame error rate (FER) performance for different levels of signal to noise ratio (SNR) for all the aforementioned coding schemes and three small V2X-compatible data frames. Our analysis shows that turbo-based coding schemes have superior BER and FER performance than 5G coding schemes for the vast majority of the considered simulation scenarios. This fact, combined with the low-complexity requirements of turbo schemes for small data frames, makes them more suitable for small-frame 5G V2X services.

Low-density parity-check (LDPC) codes have been widely considered as error-correcting codes for next generation communication systems. A good LDPC decoder design requires both implementation friendly LDPC codes and efficient decoder architectures. The quality of LDPC code is crucial in determining the coding gain and implementation complexity of LDPC hardware decoders. This paper presented a genetic algorithm (GA) based LDPC code search algorithm with hardware considerations. Regular quasi-cyclic LDPC codes are used due to its friendliness to hardware implementation. Our hardware architecture design schedules pipeline LDPC decoding operation to boost the hardware utilization efficiency (HUE) of LDPC decoder. A LDPC decoder with a block size of 12288 is implemented in FPGA to validate our code and architecture design.

In mobile communications, the quality of signal is deteriorated by fading. The spatial diversity technique is used to reduce the degradation of the signal by fading. There are several techniques to realize the spatial diversity gain, such as Single- Input Multiple-Output (SIMO), Space-Time Block Code (STBC), and so on. The SIMO system realizes the receive diversity. The error correcting code can be combined with spatial diversity gain. Low-Density Parity Check (LDPC) codes can achieve good performance approaching Shannon limit. In particular, an irregular LDPC code with optimum degree distribution achieves better performance than a regular LDPC code. The optimum degree distribution of the irregular LDPC code depends both on the channel and the system. In this paper, we derive the Eb/No thresholds of a regular LDPC codes and the irregular LDPC codes for SIMO systems with several diversity orders. The Eb/No threshold is the smallest Eb/No that the decoder can achieve the error free. We also derive the optimum degree distributions of the irregular LDPC codes for SIMO systems with several diversity orders. We show that with low diversity order, the optimum degree distributions of the irregular LDPC code depends on the diversity order largely, while with high diversity order, the optimum degree distribution depends both on the diversity order and the combining scheme largely. We also show that comparing the optimum degree distributions for MRC and STBC, when the diversity orders are the same, the optimum degree distributions are also the same.

<div> <h2>Abstract</h2> <p><strong>Objective:</strong> In the code theory, parallel concatenation of codes becomes more popular after the introduction of turbo codes. In recent years, the Low Density Parity Check (LDPC) code has found remarkable advancement and has seen them outshine turbo codes in terms of performance especially in the error floor and higher code rate. The main objective of this paper is to address the various techniques of a parallel concatenation of LDPC code in code theory. <strong>Method/Finding:</strong> To reduce the complexity of encoding and decoding for longer codes various parallel concatenation of LDPC coding methods were introduced and the performance was compared with other work. <strong>Novelty:</strong> When a longer block length is used, the parallel LDPC decoder is suffered from the complexity of prohibitive implementation. To overcome this issue and to achieve the best performance for longer codes, the different methods for parallel concatenation of LDPC codes were introduced with reduced complexity. This will helps to break the long and complex LDPC code into less complex and smaller LDPC to distribute the decoding and encoding load. Also, this will provides scalability and scope for improving the performance of LDPC codes in practical delay-sensitive and energy-aware applications.</p> <p><strong>Keywords:</strong> Parallel concatenation; LowDensity ParityCheck (LDPC); turbo codes; Parallel Concatenated Gallager Codes (PCGC)</p> </div> <div></div> <div> </div>

Harvesting energy from radio frequency signals along with transmitting data through them is appealing for different wireless communication scenarios, such as radio frequency identification (RFID) systems and implantable devices. In this paper, we propose a technique to design nonlinear codes for the use in such systems taking into account both energy transmission and error rate requirements. In particular, we propose using concatenation of a nonlinear trellis code (NLTC) with an outer low-density parity-check (LDPC) code. We design the NLTC based on maximization of its free distance. We give necessary and sufficient conditions for its catastrophicity; in order to avoid catastrophic codes, we connect each designed NLTC to a corresponding linear convolutional code allowing for the use of simpler conditions for verification. Furthermore, we use EXIT charts to design the outer LDPC code while fixing the inner NLTC. Via examples, we demonstrate that our designed codes operate at ∼ 0.8 dB away from the information theoretic limits, and they outperform both regular LDPC codes and optimized irregular LDPC codes for additive white Gaussian noise (AWGN) channels. In addition, we show that the proposed scheme outperforms the reference schemes of concatenating LDPC codes with nonlinear memoryless mappers and using classical linear block codes in a time switching mode. © 2016 IEEE.

In this paper, in order to improve bit error performance, bandwidth efficiency and reduction of complexity compared to related schemes such as turbo codes, we combine low density parity check (LDPC) codes and continuous phase frequency shift keying (CPFSK) modulation and introduce a new scheme, called ‘low density parity check coded‐continuous phase frequency shift keying (LDPCC‐CPFSK)’. Since LDPC codes have very large Euclidean distance and use iterative decoding algorithms, they have high error correcting capacity and have very close performances to Shannon limit. In all communication systems, phase discontinuities of modulated signals result extra bandwidth requirements. Continuous phase modulation (CPM) is a powerful solution for this problem. Beside CPM provides good bandwidth efficiency; it also improves bit error performance with its memory unit. In our proposed scheme, LDPC and CPFSK, which is a special type of CPM, are considered together to improve both error performance and bandwidth efficiencies. We also obtain error performance curves of LDPCC‐CPFSK via computer simulations for both regular and irregular LDPC code. Simulation results are drawn for 4‐ary CPFSK, 8‐ary CPFSK and 16‐ary CPFSK over AWGN, Rician and Rayleigh fading channels for maximum 100 iterations, while the frame size is chosen as 504. Copyright © 2006 John Wiley & Sons, Ltd.

In this paper, we evaluate the performances of the Reed–Solomon (RS) and low density parity check (LDPC) codes in order to propose an efficient coding system for the outer code in high density optical recording channels. Hard decision decoding (HDD) RS code, iterative soft decision decoding (SDD) RS code or LDPC code is used as the outer code and LDPC code is used as the inner code. We compare the bit error rate (BER) performance of each coding system for various code rates, code lengths and burst errors. Simulation results show that the LDPC code has a better BER performance than the HDD RS and iterative SDD RS codes as the outer code in high density optical channels. Therefore, the LDPC code could be more attractive as the outer code than the RS code in high density optical channels.