Voice quality analysis in wireless multimedia sensor networks: An experimental study

For Wireless Multimedia Sensor Networks (WMSN), how to increase the throughput in constrained environments has become the main challenge. Multipath routing is a promising solution because it can improve the channel utilization rate, reduce transmission delay and balance the transmission load. To pursue high efficiency for a multipath routing scheme, we need to take the characteristics of wireless environments and sensor networks into careful considerations. Based on such considerations, this paper introduces a new routing scheme which divides the whole network topology into many districts and simultaneously forwards data through these districts without interfering with each other - to achieve interference-free transmissions. Our scheme will adjust the load of each district according to the energy status of their nodes; it does not establish fixed paths in advance and will hence maintain high performance even when the topology changes rapidly. Simulation results show that, when compared with related routing schemes, our scheme can achieve higher performance at real-time transmission and meanwhile distribute transmission loads more evenly to most of the nodes in the network.

Applying multimedia to Wireless Sensor Network (WSN) adds more challenges due to WSN resource constraints and the strict Quality of Service (QoS) requirements for multimedia transmission. Different multimedia applications may have different QoS requirements, so routing protocols designed for Wireless Multimedia Sensor Network (WMSN) should be conversant of these requirements and challenges in order to ensure the efficient use of resources to transfer multimedia packets in an utmost manner. The majority of solutions proposed for WMSN depends on traditional layered based mechanisms which are inefficient for multimedia transmission. In this paper we propose a cross-layer Ant based Routing Protocol for WMSN (CARPM) by using modified ant colony optimization (ACO) technique to enhance the routing efficiency. The proposed protocol uses an improved ACO to search for the best path that are satisfied with the multimedia traffic requirements. While making best decision the weightage is given to energy consumption, and queuing delay. The proposed cross layer scheme works between the routing, MAC, and physical layers. Since, the remaining power and timestamp metrics are exchanged from physical layer to network layer. Dynamics duty cycle assignment is proposed at MAC layer which changes according to traffic rate. The presented algorithm is simulated using NS2 and is proven to satisfy its goals through a series of simulations.

The use of wireless multimedia sensor networks (WMSNs) for surveillance applications has attracted the interest of many researchers. As with traditional sensor networks, it is easy to deploy and operate WMSNs. With inclusion of multimedia devices in wireless sensor networks, it is possible to provide data to users that is more meaningful than that provided by scalar sensor-based systems alone; however, producing, storing, processing, analyzing, and transmitting multimedia data in sensor networks requires consideration of additional constraints, including energy, processing power, storage capacity, and communication. Furthermore, as multimedia sensors produce much more data than scalar sensors, more manpower is required to analyze multimedia data. To overcome these constraints and challenges, this paper aimed to propose a system architecture and a set of procedures for WMSNs that facilitate automatic classification of moving objects using scalar and multimedia sensors. Methods and standards for detecting and classifying a moving object, as well as transmission of the results, are described in detail. The hardware for each sensor node includes a built-in camera, a passive infrared motion sensor, a vibration sensor, and an acoustic sensor. An application using our proposed methods was developed and embedded in the multimedia sensor node. In addition, a sink station was set up and the data produced by the sensor network was collected by this server. The classification performance of the application was tested using video recorded by the sensor node. The effect of the proposed methods on power consumption was also tested and measured. The experimental results show that the proposed approach is sufficiently lightweight to be used for real-world surveillance applications.

Wireless sensor networks (WSNs) abiding a huge quantity of inexpensive, low consumption and intense sensor nodes and sole or additional decline or base stations. Those nodes are tiny in dimension and can carry out numerous significant affairs, as well as event sensing, in order processing, and data communication. Owed to different compensation such as simplicity of consumption, comprehensive transmission range, and identity association, WSNs have been interchanging the conventional networks. The promising and innovative network of wirelessly connected devices, which consist of video, audio streams, scalar sensor data and others, is Wireless Multimedia Sensor Network (WMSN). The multimedia data depends on superiority to overhaul (Qos) parameters, like await, channel utilization, network life time throughput and distortion etc is the main aim to optimized delivery of these networks. In multimedia network each packets are communicated with each other so not on time incoming packets and lots of packets are evenly. In WMSNs challenging task to guarantee resource constrained, high data rate, and soft delay limit beside with energy reduced. In this paper, we provide Survey on comparison of different protocol of Wireless sensor network and wirelesss multimedia sensor network like Greedy Perimeter Stateless Routing for Wireless Networks (GPSR), Real-time and Energy Aware Qos routing protocol (REAR), Temporary ordered routing Algorithm (TORA) and Dynamic source routing (DSR). This different protocols with WMSN are compared in requisites of throughput, end-to-end delay, network life time.

In the networking research community, Wireless Sensor Networks (WSN) has achieved considerable significance in the past years and it can be used in extensive variety of domains. In recent years, the tremendous growth of WSN does not meet all the necessities of environmental monitoring. Wireless Multimedia Sensor Network (WMSN) is required to fulfill the requirements of environment monitoring. In this paper, WMSN is used to monitor the agriculture soil environment. In order to ensure optimal use of the sensor nodes in WMSN and accurate access to the collected data,the routing protocols with both energy efficiency and quality of service ( QoS) properties are necessary for the transmission of photo, video and scalar data.This paper proposes a priority aware energy efficient QoS based data transmission for agriculture soil environment and also detects the pest. It utilizes the available bandwidth and data rate in the best way and in order to be more energy efficient during data transmission.For performance analysis, the proposed system is simulated using Java and the results of the experiments suggest that the proposed algorithm is more efficient compared to other methods in terms of delay and energy consumption.

One of the remarkable challenges in the area of Wireless Sensor Networks (WSNs) is how to route the collected data and transfer them in the nodes. Due to the high rate of packet loss, guaranteeing reliable and efficient packet transfer and delivery is considered to be one of the hot issues in the area of WSNs. Indeed, due to energy limitation of nodes in WSNs, reliability and energy are regarded as critical parameters in these networks. In this paper, a method has been proposed for optimizing the parameters of reliability and energy consumption in multimedia WSNs. In the proposed protocol, Increasing the Delivery Ratio with Network Coding (IDRNC) a network coding mechanism has been used for transmitting data which enhances the reliability of the network. Furthermore, reducing the number of transmissions and receptions in network nodes results in the reduction of energy consumption. In the proposed protocol, the transmitted packets are first coded and transmitted to the sink through the shortest route. In the middle of the route, in case packets are lost, median nodes can detect and recover the lost packet through the coded packet. The simulation results indicated that the method proposed in this study operates better than the LIEMRO method with respect to the following features: system efficiency, average remaining energy of the network, the number of lost packets and reliability. Keywords: Multipath Routing, Network Coding, Reliability, Wireless Multimedia Sensor Networks (WMSNs)

Wireless Sensor Network (WSN) has limited resources such as energy, computation and transmission capacity. These resources are not sufficient for transmitting large amount of data collected by the sensor nodes. Wireless Multimedia Sensor Network (WMSN) generates large amount of data that requires more energy and transmission capacity as compared to scalar data. So it is desired to perform in-network data compression in WMSN. In this paper the authors have used Principal Component Analysis (PCA) technique for data compression. PCA can be efficiently used in wireless multimedia sensor network to reduce the energy consumption, reduce the network load and prolong the network lifetime. Simulation results show that PCA based compression conserves energy of sensor nodes and prolongs the lifetime of WMSN.

In this paper, a Differentiated Services (DiffServ) architecture for Quality of Service (QoS) provisioning in Wireless Multimedia Sensor Networks (WMSNs) is presented. The proposed architecture differentiates critical real-time data from real-time multimedia data by defining six traffic classes along with their forwarding behaviour. Since Wireless Sensor Networks (WSNs) are application-specific, DiffServ for WMSNs approaches bandwidth allocation as an optimization problem. The goal is to assign bandwidth to different traffic classes in order to maximize the utilization of the whole system (subject to the overall system constraints). The proposed architecture is evaluated under different forwarding paradigms such as single-hop, multi-hop, and cluster-based. Analytical results show that DiffServ for WMSN can provide service differentiation w.r.t. the characteristics and bandwidth requirement of the traffic class.

Improvements in nanotechnology have introduced contemporary sensory devices that are capable of gathering multimedia data in form of images, audio and video. Wireless multimedia sensor networks handles such type of heterogeneous traffic. Since these networks are an emergent of wireless sensor networks, they inherit constraints that exist in these traditional networks. This paper is a survey of characteristics and requirements of wireless multimedia sensor networks and approaches to mitigating existing challenges in these networks. Further presents a review of recent research on multipath routing protocols and multi-channel media access protocols that offer quality of service assurances in handling multimedia data. The survey shows that there still exist bottlenecks in current routing solutions when applied to wireless multimedia sensor networks due to the nature of traffic involved as well as inherent characteristics, requirements and constraints. The findings are useful in the discovery of solutions to the challenges and issues. The authors further suggest approaches and plausible solutions to the problems in order to assist in the development of protocols that achieve quality of service in wireless multimedia sensor networks.

In recent years, there has been intense research and considerable progress in solving numerous wireless sensor networking challenges. However, the key problem of enabling real-time quality-aware multimedia transmission over wireless sensor networks is largely unexplored. The large amount of data generated by most multimedia applications (compared to traditional scalar sensor networks), along with the higher QoS requirements make it difficult to meet the low energy use requirements of practical sensor networks. We explore the use of compressed sensing (aka “compressive sampling”) to reduce the energy required to encode and transmit high quality video in a severely resource-constrained environment. In this chapter, we will examine some of the major challenges of wireless multimedia sensor network (WMSN) implementation. Specifically, we examine what it would take to develop a WMSN that has similar performance (and restrictions) as a traditional scalar wireless sensor network (WSN). We then examine how we can use the new paradigm of compressed sensing (CS) to solve many of these problems.KeywordsSensor NodeWireless Sensor NetworkDiscrete Cosine TransformVideo QualityCompress SenseThese keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

New security approach in real-time wireless multimedia sensor networks

With the advancement of wireless sensor networks (WSNs) and technology, applicability of WSNs as a system is touching new heights. The development of multimedia nodes has led to the creation of another intelligent distributed system, which can transfer real-time multimedia traffic, ubiquitously. Wireless multimedia sensor networks (WMSNs) are applicable in a wide range of areas including area monitoring and video surveillance. But due to unreliable error-prone communication medium and application specific quality of service (QoS) requirements, routing of real-time multimedia traffic in WMSNs poses a serious problem. The paper discusses various existing routing strategies in WMSNs, with their properties and limitations which lead to open research issues. Further, detailed classification and analytical comparison of discussed protocols are also presented.

The appearance of wireless sensor networks has attracted worldwide attention. Wireless Sensor Networks (WSNs) and Wireless Multimedia Sensor Networks (WMSNs) consist of wirelessly interconnected sensor nodes organised arbitrarily or deterministically in an environmental area which can gather, distribute and route information in different application areas. Power consumption in these networks is the foremost problem. WSNs are a recent generation of sensor networks, have an ample range of applications, their expansion and application will convey about extensive impact in human life and construction of all areas. Some of the applications include disaster management, landslide detection, glacial monitoring, wildlife tracking, healthcare, military applications, environmental monitoring, security surveillance, industrial process control and a large number of applications to robotics and Internet of Things (IOT) projects. This paper will demonstrate the elementary description of WSN followed by different energy-efficient power consumption protocols. Here we have performed the comparative performance analysis of different energy-efficient protocols. In our work we have compared MODLEACH with TSEP followed by TSEP with RELSEP.

Geographic Multipath Routing based on Triangle Link Quality Metric with Minimum Inter-path Interference for Wireless Multimedia Sensor Networks

Congestion in Wireless Sensor Network (WSN) occurs when traffic load allocated to any sensor node is beyond its capacity. It is necessary to control the congestion traffic to support traditional quality of service (such as packet loss ratios, packet delay, wasting energy and throughput) especially, multimedia application of Wireless Multimedia Sensor Network (WMSN). Congestion control in WSN has been shown to be very effective with respect to extending lifespan of system. Hence to avoid the congestion in WSN, we proposed an efficient protocol called Priority-based Congestion Control Protocol (PCCP) which prevents an upstream congestion in WSN. The PCCP creates priority table based an importance of each node, and then sends this information to all the nodes within the network. Secondly, the major function of PCCP is to measure congestion level in the network using ratio of packet inter-arrival time along over packet service time. PCCP uses to control upstream congestion along with congestion degree and packet table. PCCP is hop-by-hop upstream congestion control protocol for WSN. PCCP provides work for packet-based computation to optimize congestion control. It can work under both single path & multipath routing. PCCP ensures guarantee of packet loss as well as delay, resulting each node can avoid unfairness and achieve flexible throughput. In this paper, we have proposed that PCCP provides better QoS by controlling network recourse management and network traffic to consuming efficient energy.